Gw-instek APS-1102 Control Software User Manual Manual de usuario descargar pdf (Pagina 35)

4.9 System Setup

4-11

4.9 System Setup

When [Tool(T)] - [System Setup(S)] is selected, the [System Setup] dialog box appears.

Figure 4-13 System Setup Dialog Box

Model Select the model name of the device to be connected.

(Only APS-1102 can be selected.)

Interface Select the external interface of the device to be connected.

(Only USBTMC can be selected.)

Serial NO Input the serial number of the device to be connected.

Set a 7-digit number in the APS-1102.

If this number is not correct, the system cannot communicate with the device.

When [Model], [Interface] and [Serial NO] are set and the

OK button is clicked, the software

communicates with the device according to the set conditions. If the communication is established

with the device under the set conditions, the device enters into the online status.

If the communication fails, the following message appears.

Figure 4-14 System Setting Confirmation

If the

OK button is clicked, the message and system setup dialog box are closed and the device

enters into the offline status. If the Cancel button is clicked, the system setup dialog box reappears.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 133 134

Sin comentarios

Gw-instek APS-1102 Control Software User Manual Manual de usuario Pagina 35