Gw-instek GDM-8261A Remote Viewer(DMM-Viewer) Guide Manual de usuario descargar pdf (Pagina 7)

SETUP

Connection

When using DMM Viewer in Conjunction with the GDM-8261(A), use the

following instructions to set the DMM to RS232 or USB mode each time the

DMM is turned on.

NOTE: If you are using DMM Viewer in software demonstration mode (no

hardware) skip the Connection and Configuration procedure and install the

DMM Viewer software, page 10.

Note

The following procedure describes a USB

connection configuration and procedure. Skip

this step if connecting with an RS232 cable.

1. Configure the

DMM for USB

1. Press the Shift key, the 2

(Menu) key, then the Left key

until the I/O configuration

menu appears.

2ND

2. Press the Down key then

press the Left key until the

USB selection display

appears.

3. Press the Down key. The

USB ON/OFF selection

appears.

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Sin comentarios

Gw-instek GDM-8261A Remote Viewer(DMM-Viewer) Guide Manual de usuario Pagina 7