
PSW Series Programming Manual
82
Sets or queries the unit operation mode. This
setting is only applied after the unit has been reset.
SYSTem:CONFigure:MSLave { 0 | 1 | 2 | 3 | 4 }
SYSTem:CONFigure:MSLave?
Series mode is only supported for 30V, 80V and
160V models.
Master/Parallel 1 (2 units)
Master/Parallel 2 (3 units)
SYSTem:CONFigure:OUTPut:EXTernal
[:MODE]
Sets the external logic as active high or active low.
This setting is only applied after the unit has been
reset.
SYSTem:CONFigure:OUTPut:EXTernal[:MODE]
SYSTem:CONFigure:OUTPut:EXTernal[:MODE]?
SYSTem:CONFigure:OUTPut:PON[:STATe]
Sets the unit to turn the output ON/OFF at power-
up. This setting is only applied after the unit has
been reset.
Comentarios a estos manuales