Gw-instek PSU-Series Programming User Manual Manual de usuario descargar pdf (Pagina 43)

REMOTE CONTROL

4. Terminate the OUT port of the last unit with

the end terminal connector included in the

PSU-232 or PSU-485 connection kit.

5. Press the Function key to enter the

Normal configuration settings for

the master unit.

Page 21

Set the following settings:

F-70 = 1 or 2

Configure the master unit as you

normally would for RS232 or

RS485 remote control.

F-71 = 0~7

Set the baud rate (set all units

the same).

F-72 = 1

Set to 8 data bits.

F-73 = 0

Parity to none.

F-74 = 1

1 Stop bit.

F-75 = 1

Set the UART TCP to TDK

(emulation mode).

F-76 = 00~31

Set the address of the master

unit. It must be a unique

address identifier.

6. Press the Function key to enter the

Normal configuration settings for

the slave(s).

Page 21

Set the following settings:

F-70 = 2

Set the slave unit to RS485.

F-71 = 0~7

Set the baud rate (make all

units, including the master, the

same baud).

F-72 = 1

Set to 8 data bits.

F-73 = 0

Parity to none.

F-74 = 1

1 Stop bit.

F-75 = 1

Set the UART TCP to TDK

(emulation mode).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 127 128

Comentarios a estos manuales

Sin comentarios

Gw-instek PSU-Series Programming User Manual Manual de usuario Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Gw-instek PSU-Series Programming User Manual