
GSP-930 Programming Manual
26
Connect an Ethernet cable from
the network to the rear panel LAN
port.
>More 1/2[F7]>RmtInterface>
LAN[F2]>LAN Config[F1] to set the LAN
settings:
Sets the default gateway.
Sets the DNS server address
Toggles the LAN
configuration between DHCP
and manual settings.
2. Press Apply[F6] to confirm the LAN
configuration settings.
The LXI icon turns green when connected
to a LAN and will flash if the
“Identification” setting is on, see page 31.
The password on the LXI webpage can be set
from the spectrum analyzer. The password is
shown in the system information.
By default the password is set to: lxiWNpwd
3. Press
>More 1/2[F7]>RmtInterface
Config[F2]>LAN[F2]>LXIPassword[F2] to set
the password.
Comentarios a estos manuales